User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
2-284 Function RPT Landis & Staefa Division
Permissible values for the parameter specified immediately above. In the example:
CTYP=MW
Instead of a fixed parameter value, range definitions and comparison operators as per
the following table are permissible:
General: Operation and Value or Only Value
Operations for Numerical Values (x,y):
x(..y) Equals x or within x..y (default)
<>x(..y) Does not equal x or outside x..y
>x, >=x Greater than x, Greater than or equal to x
<x, <=x Less than x, Less than or equal to x
Operations for Bitset Values (x,y):
x&y Equal - Only Bit x,y set (default)
<> x&y Unequal - Only Bit x,y not set
and x&y AND Expression - Bit x and y set
or x&y OR Expression - Bit x or y set
not x&y Inversion - Bit x,y not set
A total of up to 8 masking parameters can be defined at this level.
Definition of parameter to be reported with its value.
Up to 10 operating parameters can be specified at this level for reporting.
Is a status report required, "Yes/No".
Parameter Value
n. Masking Param.
1. Operating Param.
n. Parameter
with Status Rpt.=No