User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
2-290 Function RPT Landis & Staefa Division
Specification of the selection criterion "message priority", see parameter MSGp.
A single parameter with its respective value or range of values can be specified as an
additional selection criterion.
The same rules apply as for the PNX report.
General: Operation and Value or Only Value
Operations for Numerical Values (x,y):
x(..y) Equals x or within x..y (default)
<>x(..y) Does not equal x or outside x..y
>x, >=x Greater than x, Greater than or equal to x
<x, <=x Less than x, Less than or equal to x
Operations for Bitset Values (x,y):
x&y Equal - Only Bit x,y set (default)
<> x&y Unequal - Only Bit x,y not set
and x&y AND Expression - Bit x and y set
or x&y OR Expression - Bit x or y set
not x&y Inversion - Bit x,y not set
Explanations regarding the report content
Current point state
Point in alarm:
*, **, ***
Point in normal state:
., .., ...
Point in acknowledged state:
=, ==, ===
Time and date of alarm start.
Time and date when last alarm ended.
Time and date of last alarm acknowledgement.
Acknowledged alarm messages have the following STAP markers:
=== --> (MSGP=3)
== --> (MSGP=2)
= --> (MSGP=1)
blank --> (MSGP=0)
Other higher priority STAPs (?HW, ?SW, etc.) are not overwritten when acknowledged.
Code of user who made the acknowledgement plus the number of alarms (ALcnt) that
have been received since the last acknowledgement.
2.28.24 STA, Statistic Register Report
Refer to function STA,LIST
•
Output to any terminal (display, printer terminals).
•
Output to Vtxx terminal with form feed.
•
Simultaneous STA outputs from several DCS servers.
Selected priority
Masking param.
STAP
ALBeg
ALend
ALack
ALvis and ALcnt
Advantages over STA
function