User Manual

Siemens Building Technologies VISONIK DCS Functions and System Messages VVS18 CM2U8567E / 04.1999

Landis & Staefa Division Function BYE 2-11

2.4 BYE Exit from Terminal

Entry into dialogue with the VISONIK DCS is through a personal 'User Code' and a

'Password'. The 'Password' and "Extra Device(s)" (for dialogue) are defined with

Function KEY.

To exit from the system requires no password, simply the Function BYE. With this action

an exit is made from all those "Extra Device(s)" at which log-in took place using the

same respective password. Any further access is blocked until a user again logs-in with

his 'User Code' and 'Password'.

2.4.1 Initial Access and Handling

Call-up is made through "Ctrl/P" and by entering the abbreviation, BYE

VISONIK then responds with the acknowledgment "Goodbye".

T1 08:05:14 Function =PNT : BYE Goodbye

Log-in and log-out messages are output to those terminals as defined in parameter

DevLog, in the form:

If a system user does not log-out and no inputs are given, a timer is started which allows

further access only for a specific period. This period is defined in parameter ATMO

(Operator Timeout) for the relative terminal and automatically logs-out the user

concerned after timeout.