User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
2-330 Function TRR Landis & Staefa Division
Automatic picture/point selection
When the reaction PICT is triggered, the VISONIK DCS automatically displays the
selected picture in VISONIK-Insight.
The picture is only displayed if VISONIK Insight is free. Otherwise, it is saved until it is
opened manually.
Specification of the picture to be displayed.
In the case of reaction programs whose "reason" is a point change (TRR/SRR), the user
can enter an "F" in the reaction entry instead of a fixed picture number. With this entry
the picture that has been assigned to the respective "reason" address using the function
COS,PICT (???) or the function PICT will be automatically displayed.
The PICT parameter contains the number of the picture on which a given point is
displayed.
VISONIK Insight, Output device number (T1..T15)
If a printer channel is selected as graphic device, the encoded picture number will be
printed only.
The VISONIK DCS executes the same reaction with the further addresses as with the
address defined under "Reaction =". This feature allows for reaction entries to be
economised.
The user can assign up to four different further addresses to each reaction entry,
provided the reaction is one that modifies point parameters
(Reaction =UA/TA) or prints slave messages (Reaction =SLV).
For each reaction entry, the user can use the message mask to define which output
devices of the VISONIK DCS are to register the reaction:
Message Mask =MSGDEV : ?
MSGDEV: M1
MM00: M1&M2
:
MM15: M1&M2
Message Mask =MSGDEV :
Message Mask =MSGDEV means that the reaction will be registered on the message
devices that are listed according to message priority in the parameters DSM0..DSM3
(point type SY) of the point specified under "Reaction=".
The MSGDEV mask also takes device allocations with group reactions (alternative or
auxiliary devices) into account.
2.32.3 LI, List Data Registers
The LI operation can be used to selectively list the reaction entries. The contents of the
list can be filtered according to the following criteria:
•
by a specific time
•
by a specific time period
•
by entry numbers
•
by reactions
If the reaction type CT, MC or CB is entered at the prompt "Reaction=?:", the user can
make a finer selection according to text or task number.
Reaction PICT
Picture number
Graphic devices
1. further address
n. further address
Message mask