User Manual

ManualsBrandsSiemens ManualsBuilding automationMounting and Installations Handbook Building Process Station, BPS P-Bus, I/O Module System

361

362

363

364

365

366

367

368

369

370

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies

2-348 Function TXIU Landis & Staefa Division

Type of Text=Ip :

Last Text Change : 19.01.1999 15:38:34 Alfred Gisler

Operation=CHNG : ?

0 CHNG = Change in Active Language

1 ALAN = Change in all Languages

2 LCTX = List Changed Text Entries

3 LDIF = List Language Discrepancies

4 COPY = Copy or Move a Textblock

5 LABC = List Entries Alphabetically

6 LIST = List Text

Operation=CHNG :

2.34.3 Select or Search for a Specific Text

2.34.3.1 Text Entry Number (Number=1:)

Entries lp1 to 9 of the TXIU text register are reserved for identifying the three registers

TXIU,lp and TXIU,Up and TXIU,C and are not to be used.

However, the entries 1 to 9 of registers TXIU,Up and TXIU,C may be used.

Depending on the application, VISONIK DCS can accept one or more of the following

inputs:

–

A single number

(for CH, AL, LI).

–

Range of numbers

(e.g. 20..30) (for CH, LABC, LI).

In Operation CH an input of a range of numbers provides a listing of the specified

range.

–

"*" character for all text lines (for CH, LABC, LI).

In Operation CH an input of "*" provides a listing of the complete text register.

–

Question mark "?" for search (for CH, AL, LI).

–

The character

"T"

This operation allows bypassing dialogue questions and directly entering text.

Example: TXIU,Up,CH,T,100,:Text"

This function is especially used by VISONIK tool.

If a number is specified which is unknown to the system a "Help" text is output showing

the valid range of inputs for the relative register.

Operation=CHNG :

Number=1 : 999999

Number=?, * , T, (1..3047):

2.34.3.2 Search for Text in Register (Txt.Search (*/%) =:)

Before making a text entry it is useful for an operator to know if such text is already

available in the register.

"Txt.Search" is a VISONIK DCS program to search for text when using Operations "CH",

"AL" and "LI".

Searching is limited to the selected Text Register and is made only in the related

operating terminal's active language.

Operations

reserved

Number=1:

:Search Text"