User Manual

Siemens Building Technologies VISONIK DCS Functions and System Messages VVS18 CM2U8567E / 04.1999
Landis & Staefa Division Function TXIU 2-351
2.34.5.2 Change Text
There are two possibilities for changing an existing text:
a) Change the complete text entry.
b) Change a text using "Line Editor".
T8 11:03:22 Function=PNT : TXIU
Type of Text=Ip : UP
Last Text Change : 19.01.1999 15:38:34 Alfred Gisler
Operation=CHNG :
Number=1 : 156
Up0156:
Up0157:
Explanation
Up0156 = kWh: After selecting the status
text number 156, VISONIK DCS
outputs the text associated
with this number.
Up0156 = kWh:mA The new text is entered here.
= mA After pressing <CR>, the DC
Server acknowledges the entry.
A simple 'Line Editor' has now been implemented for VT100 similar terminals.
The use of a 'Line Editor' is practical when only small changes have to be made in
existing lengthy text.
The Editor can be used in operations CH and AL.
The Editor only supports visible characters. This means must not contain any control or
special characters (e.g. characters entered by pressing <TAB>, <CTRL><G>, <BELL>).
Example for an Information (I) Text Entry
I 0001= COLD WATER PUMP SWITCH:
I 0001: Ctrl/B <--- Activate 'Editor'
HOT WATER PUMP SWITCH <--- Edit window
= HOT WATER PUMP SWITCH: <--- Acknowledged after <CR>
I 0002: _ <--- Return to input mode
Change the Complete
Text Entry
Change Text with Line
Editor
Note