User Manual

Siemens Building Technologies VISONIK DCS Functions and System Messages VVS18 CM2U8567E / 04.1999
Landis & Staefa Division Function TXIU 2-355
ctrl/P
1:T4 15:54:31 Function=PNT:
Type of Text=Ip :
Last Text change : dd.mm.yyyy hh:mm:ss
Operation=CHNG : copy
from Language=0 :
from Type of Text=P : ?
0 P = Parameter Names (6 characters)
1 S = System Texts (4 characters)
2 N = System Texts (8 characters)
3 Q = Parameter Names (32 characters)
4 L = System Texts (16 characters)
5 V = System Texts (32 characters)
6 Up = Status/Unit Texts (8 characters)
7 Ip = Point Texts (up to 32 characters
8 M = Macro Texts (64 characters)
9 C = Clear Texts (60 characters)
10 Hp = Help Texts (80 characters)
11 Ug = Global Units (8 characters)
12 Ig = Global Point Texts (32 chars.)
13 Hg = Global Help Texts (80 chars.)
14 Um = GC Units (8 characters)
15 Im = GC Point Texts (32 chars.)
from Type of Text=P : um
from Text No.=0 : 100
to Language=0 : 1
to Type of Text=?0 : ?
6 Up = Status/Unit Texts (8 characters)
7 Ip = Point Texts (up to 32 characters
to Type of Text=?0 : up
to Text No.=0 : 40
Number of texts = 1 : 15
Explanation
•
When selecting the
TXIU
function, the only allowable target registers are the two text
registers TXIU,lp and TXIU,Up.
•
When selecting the
TXCM
function, the only allowable target registers are the three
text registers TXCM,M and TXCM,C and TXCM,Hp.
•
If a wrong input is given, the DC Server responds with:
No Success - Blocked Option
•
On copying from a lengthy text register to a short register (e.g. from Clear text to
Status text) the text is simply truncated since Clear text
(60 characters) is too long for the Status text Register(8 characters).
Conversely, remaining characters are overwritten with ASCII characters "ETX" (End
of Text).