User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
3-4 System Messages --- Event Messages Landis & Staefa Division
The following table specifies, dependent on the point type, which parameters are
displayed in these fields.
Using message suppression
$SY,MSGS+=PaNa
, the report lines at these positions can
be supplemented with the associated parameter names.
Using
$SY,MSGS-=PaNa
the parameter names can be hidden from the report lines.
3.2.2 Point type dependent information fields
RULE: The following rules hold for the tables below:
Information in braces {} appear as needed.
The parameter names, whose values are to be displayed in the message, are displayed
in the relevant information fields.
Example:
The "main value" field of an AO point is defined with AO
TXU, that is, upon an actual printout of the message here,
the values of the AO and TXU parameters are displayed, e.g., 60 %
Permanent characters or commentary text within information fields are written using
quotation marks (""), e.g., "Ri-"
Information without a parameter reference (e.g., active priority for DO or FL setpoints)
are written in italics.
Mutually exclusive information is set in parentheses () and separated using "|"; the
presentation priority is specified from left to right.
Example:
The 'Status' field is to be defined with:
(ERSTA<>0 | OPSTA<>0),
that is, upon actual printout of the message at this position, the
ERSTA value is given, insofar that ERSTA<>0.
If ERSTA=0 at this time, then the OPSTA value is displayed at this
position insofar that OPSTA<>0.
If OPSTA is also 0, then the field remains blank.
Displayed text has the following format:
AI=(TXU): Array begins with UnitText with the no. from the TXU parameter.
Point type dependent
information 'M', 'S', 'I'
Optional info
Parameters displayed
Permanent text
Other info
Mutually exclusive
information
Text