User Manual

Siemens Building Technologies VISONIK DCS Functions and System Messages VVS18 CM2U8567E / 04.1999
Landis & Staefa Division Function CAL 2-17
1st case: No entry found --> New entry
T8 15:29:42 Function=PNT : CAL
Mode=SCAL :
Operation=LIST : CHNG
Calendar/PS=. : ?
Individual Group 1..7 (e.g. 1, 2, 5, etc.)
Group combination 1..7 (e.g. 2&3&5, -5&6, *, etc.)
Technical Station Address (e.g. $23'PS) or User Address
(Combination of Groups and Station Addresses not possible!)
Calendar/PS=. : 1
Date=24.07.1996 : ?
Date (e.g. 21-Dec-93)
Date Range (e.g. 21-Dec-93..31-Dec-93)
Holidays (e.g. Easter)
Holiday + No.of Days (e.g. Easter+1 =Easter Monday)
Holiday - No.of Days (e.g. Whitsun-10 =Ascension
Date=24.07.1996 : 31.12.96
Special Day =31.12.1996/Tu=Su:
Repetition=No : ?
Repetition=(No,Yes) :
1 31.12.1996/Tu =Su
Calendar/PS=1 :
Input of a calendar or PS address possible:
Calendar: Special days are assigned to one of the seven available standard
register (groups 1..7).
PS address: Special days are assigned to the register available for each PS.
At this point the user may enter the required date, date range with day, month and year,
or one of the following standard holidays:
–
Good Friday
–
Easter
–
Ascension Day
–
Whitsun
Other possible inputs:
Whitsun +1, Christmas day -3, etc.
Holidays, in the sense of this Function, are special days whose dates can be uniquely
calculated for each year.
At this point the user can allocate the previously defined calendar entry to a particular
day of the week or one of the 'Sd1..Sd7' special day types. 'Sd1..Sd7' special days are
defined in the time reaction register (TRR) program.
If a special day repeats every year on the same day this entry can be confirmed.
Otherwise the special day definition will be cleared once it has been executed.
This dialogue question
does not
appear for pre-calculated holidays such as Easter,
Whitsun, etc.
Elapsed special days without repetition (=NO) are cleared.
Calendar/PS #
Date
Special Day
Repetition
Note