User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
3-10 System Messages --- Parameter Change Messages Landis & Staefa Division
3.3.1 Causes for parameter change reports and terminal assignment
Hand:
Operator change using a terminal (refer to $S, parameter DEVPCH).
Process reaction:
Programmable device mask (refer to $S, parameters MM00..MM15 or MSGDEV), or
also no message for reaction initiation.
Date reaction:
Identical to PRK.
Date reaction to "updating":
Identical to PRK.
Chain reaction:
Identical to PRK.
Collective reaction:
Identical to PRK.
Maintenance reaction:
Identical to PRK.
Time reaction:
Identical to PRK.
"Upgrading" time reaction:
Identical to PRK.
Peak demand limiting:
Messages are written into the device mask that is defined in the LSP point of the
DEVLS parameter.
Cyclic switching:
Messages are written into the device mask that is definedin the LSP point of the DEVLS
parameter.
Sequential time reaction of the suppression (via classes):
Messages to MSGDEV terminals (such as event messages).
Multiple-point parameter changes:
Messages to MSGDEV terminals (such as event messages).
Parameter change in the VISONIK DCS system because of a local change in a
configuration parameter in a PS partner station.
Messages are output on terminals of the $Sy.DEVINI parameter. (Messages are
suppressed when the$Sy,MSGS parameter is sent to PaX.)
Reason for a change in other parameters after altering the VERS/SW version
parameter.
Messages are output on MSGDEV terminals (as for event messages). (Messages are
suppressed if the $Sy,MSGS parameter is sent to PaX.)
Reason for other parameter changes after a change in the parameter OPMO/ Operating
Modes DS/PS. Messages are output on MSGDEV terminals (such as event messages).
(Messages are suppressed when the $Sy,MSGS parameter is sent to PaX.)
HAND
PRK
DRK
!DRK
KRK
SRK
WRK
ZRK
!ZRK
LSP
ZYKS
AZ
PNX
BPS
VERS
OPMO