Manualshelf

User Manual

ManualsBrandsSiemens ManualsBuilding automationMounting and Installations Handbook Building Process Station, BPS P-Bus, I/O Module System
411412413414415416417418419420
CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
3-34 System Messages --- DCS Messages Landis & Staefa Division
CTYP=ctype ---> Wrong Point Type
PTYP 00:00:00 NAME
CTYP=ctype
---
> Wrong Point Type
->DEVINI (M.TYF)
The point with NAME (or rather, where available, the point with a TA) transmits an event
to the system. If, in the DC Server, a point with another type is generated at this
address, a message occurs. If, as yet, no point has been generated in the DC Server at
this address, then this message is output if the $S,TRBI=200 diagnostic is switched on.
Such messages can also occur as a result of defects in connectors or modules
(incorrect addresses and IDCs).
Locate the malfunction and eliminate it.
Explanation
Action