Manualshelf

User Manual

ManualsBrandsSiemens ManualsBuilding automationMounting and Installations Handbook Building Process Station, BPS P-Bus, I/O Module System
421422423424425426427428429430
CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
3-44 System Messages --- DCS Messages Landis & Staefa Division
In all cases contact Landis & Staefa FS&PM, providing as much information as possible
about the system behaviour during the ten minutes before this error message appeared.
If this error repeats, try VE,IM or VE,REA or VE,DM.
Group B
These messages appear whenever the reserved disk space has been fully used up by
the process image, and further data points still have to be generated.
This message can also be falsely printed if the DC Server is heavily overloaded. Please
send these messages to Landis & Staefa FS&PM.
Restructure the disk using SYS,DISK,AEND and BOO,N.
Group C
This error can occur after a power failure or other system malfunction.
This is a warning indicating the range where data points could be faulty; their
configuration should be checked.
Action
Action
Action