User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
3-52 System Messages --- DCS Messages Landis & Staefa Division
GRAF: xxx [Error Text]
STAP TYP 00:00:00 NAME
GRAF: xxx [Error Text]
->MSGDEV (M.FSX3)
This error message appears with a different error text if an error occurs during the
output of a DPP graph (xxx) on a display terminal with the address NAME or upon
accessing a DPP graph.
Possible error messages [Error Text]
[1] Terminal defect or no hardware
An attempt has been made to output a graph on a faulty or non-existing terminal.
On starting a graphic output, the terminal's status is checked. Depending on the function
involved, the time between starting a graphic display and its actual output can take from
5 seconds up to 5 minutes.
A further check is made immediately before the output of the graph (see under [3]).
Check the terminal.
[2] Terminal not supported
An attempt has been made to output a graph on a terminal which does not support the
graphics program.
Select another terminal.
[3] Terminal output error
Shortly before a graphic output, the terminal reported a fault which had not been
detected upon actually starting the graph output.
Check terminal.
[4] DAPRO channel: Range too big.
A maximum of 1000 values per DAPRO channel can be logged. The number of values
to be logged is determined from the x-axis time range and the recording interval.
This range has been exceeded in the current graph.
Select a smaller time range.
[5] Axis system missing
The co-ordinate system is missing from the current graph. Such a graph is not
processed.
Enter the appropriate co-ordinate system.
[6] Bitmap busy. Please wait
There is only one bit map available per system, i.e., only one graph can be processed
per system.
Stop other graphic outputs or wait until the bit map is free.
After about 3 minutes the bit map will be automatically enabled.
[7] Graph full
On entering additional text a graph may exceed the available memory space.
Remove additional text.
[8] Unknown graph entry number
An illegal graph number has been detected upon the change or output of a graph
Inform L & S Projects Dept. giving all details.
[9] Graph defective. Please delete
The internal structure of the graph is faulty.
If this only occurs once, then delete the graph and regenerate it. Otherwise, contact the
L & S Projects Dept.
Explanation
Cause
Action
Cause
Action
Cause
Action
Cause
Action
Cause
Action
Cause
Action
Cause
Action
Cause
Action
Cause
Action