User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
3-54 System Messages --- DCS Messages Landis & Staefa Division
IDC = vvv --> xx => zz
STAP TYP 00:00:00 NAME
IDC = vvv --> xx => zz
->MSGDEV (M.MDCH)
Module change detected at the PS. The old module (IDC=vv) was replaced by the new
module (IDC=xx).
The following holds for 'zz':
0: In operation
1: No hardware
2: No module
3: SW change
4: Module error
5: HW IDC = ??
Plug in the correct module type or delete the old module points and then generate the
appropriate new module type.
Ensure the wiring is correct.
After a module change, check the parameters of the point involved.
Explanation
Action
Note