User Manual

Siemens Building Technologies VISONIK DCS Functions and System Messages VVS18 CM2U8567E / 04.1999
Landis & Staefa Division System Messages --- DCS Messages 3-125
Type IOX4 messages
error=1 R0=x
#$Tx: ADDP channel, Partner PS missing (SL.lus)
Check the software configuration of the connecting channel.
error=2 R0=x
#$Tx: ADDP channel, rx buffer too small.
Check the software configuration of the connecting channel.
error=3
#same as error=1, detected in AD$IDO
Check the software configuration of the connecting channel.
error=5 R0=x, R1=Parter PS
#$Tx: Modem, G$DL11 with Carry set
Please collect these messages and forward to Landis & Staefa FS&PM.
error=13 R0=x, R1=Parter PS
#$Tx: Tele Terminal busy, please wait.
Please collect these messages and forward to Landis & Staefa FS&PM.
error=14 same as error=5, but detected in DIAG
Type IPSU messages
error=2
#TA$ual: illegal UAL reference
---> big search through UAL
Occurs often if there are many UA entries or changes.
Start VE,UAL with a lower system loading (can take several hours). If unsuccessful,
collect such messages and forward them to Landis & Staefa FS&PM.
error=3 R0=TA
#TA$ual:
UA found with big search
Occurs often if there are many UA entries or changes.
Start VE,UAL with a lower system loading (can take several hours). If unsuccessful,
collect such messages and forward them to Landis & Staefa FS&PM.
error=4 R0=TA
#TA$ual: TA no longer exists
Occurs often if there are many UA entries or changes.
Start VE,UAL with a lower system loading (can take several hours). If unsuccessful,
collect such messages and forward them to Landis & Staefa FS&PM.
Type SYN1 messages
error=1
text segment with illegal BL detected
Please collect these messages and forward them to Landis & Staefa FS&PM.
Explanation
Action
Explanation
Action
Explanation
Action
Explanation
Action
Explanation
Action
Explanation
Action
Explanation
Action
Explanation
Action
Explanation
Action