User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
2-46 Function CMB Landis & Staefa Division
2.7.4 LFCO, Fault Condition Summary
Operation LFCO provides a listing on the user's terminal or printer which gives a review
of 'fault condition' messages held in the CMB. These messages are tabulated together
with the current warning condition (WCON) state marker, related address (ADDR, TA)
and the number of related fault condition states (Normal: FCON=0, Fault: FCON=1)
during the specified interval, listed in a table.
Contrary to Operation LIST, messages can be selected according to the following
criteria:
–
Statistics time interval
–
Messages with addresses
T8 10:17:44 Function=PNT : CMB
Operation=LIST : LFCO
from 09.08.1996/Fr 04:15: -1
11.08.1996/Su 00:00
upto 12.08.1996/Mo 10:18:
12.08.1996/Mo 10:18
Address=$RI1 : $100*
CMB 10:18:07 Start of D A T A - L I S T 12.08.1996/Mo
T8
from: 11.08.1996/Su 00:00
upto: 12.08.1996/Mo 10:18
Message Category = Messages with Point Addresses
Selected Address Range = $d100'000...$d100'377
ERSTA : 0 1 2 3 4 5 6 7
----------------------------------------------------------
. PS rt'z 2 . . . . . . .
. AI RO'OM'TEMP"01 . . . . . . . .
. AI OU'TS'TEMP"01. . . . . . . 1
DI DI'MO'TEST"02 1 1 . . . . . .
. DI TE'ST'DIGI"01 1 . . . . . . .
CMB 10:19:08 End of D A T A - L I S T 12.08.1996/Mo
T8
Operation=LIST :
2.7.5 LIRO, List Messages in Reverse Order
Operation LIRO lists the requested number of messages in reverse order, i.e. the most
recent message appears at the beginning and the oldest at the end.
See Operation LIST for selection of message types.
Function LIRO normally works with 'Criterion=ADR'. If a different criterion is desired,
enter CTRL/H after the question 'Adress'
The 1
0
most recent messages shall be listed in groups of five messages in reverse
order.
Note:
Pressing <CR> each time at "Number=5:" gives the required number of five messages
per group.
CTRL/H
Example