User's Manual

Configuration with the Primary Setup Tool
Operating Instructions SCALANCE W 788-1pro / SCALANCE W 788-2pro
C79000-G8976-C184-01
35
4.5 Primary Setup Tool via the Command Line
Syntax
You can also use the Primary Setup Tool from the command line of a DOS prompt.
The syntax is as follows; optional parameters are shown in square brackets:
s7wnpstx MAC address -DHCP[=client ID]
s7wnpstx MAC address -RESET
s7wnpstx MAC address IP address subnet mask [router address]
The following table explains the parameters:
Command Description Comment
MAC address
The MAC address of the module to
be configured.
-DHCP
Specifies whether or not the IP ad-
dress is obtained from a DHCP
server.
client ID
A unique identifier for the device. If
this parameter is not specified, the
Primary Setup Tool uses the MAC
address as the ID.
Optional.
-RESET
Sets the IP address to 0.0.0.0 .
IP address
The IP address of the module to be
configured.
subnet mask
Subnet mask of the module to be
configured.
Router address
The IP address of the default router. Optional.