User's Manual

Configuration Using Web Based Management and the Command Line Interface

There is no automatic restart. This allows you to enter data using Web Based Man-

agement before the restart. The changes take effect only after a restart.

In User mode, this button is not visible.

Reset to memory defaults and restart Button

Click on this button to restore the factory configuration settings. The protected de-

faults (see above) are also reset. An automatic restart is triggered.

Note

By resetting all the defaults, the IP address is also lost. The SCALANCE W 788

can then only be accessed using the Primary Setup Tool unless the IP address is

obtained over DHCP.

In User mode, this button is not visible.

Syntax of the Command Line Interface

CLI\SYSTEM\RESTARTS>

Command Description Comment

restart

Restarts the SCALANCE W 788. The restart command can

be invoked in all menus.

memreset

Resets the factory settings and trig-

gers a restart (the protected settings

are also deleted).

defaults

Resets the factory settings and trig-

gers a restart (the protected settings

are not deleted).

Operating Instructions SCALANCE W 788-1pro / SCALANCE W 788-2pro

C79000-G8976-C184-01