User's Manual

Configuration Using Web Based Management and the Command Line Interface
from <text for the
sender field>
Specifies the sender of E-mails from
the SCALANCE W 788.
6.2.7 SNMP Config Menu Command
Configuration
Select the check boxes of the entries according to the SNMP functionality you want
to use. SNMP Version 3 allows you to assign rights at the protocol level. You spec-
ify groups and users in the submenu. You can also make entries there if the
SNMPv3 enabled check box is not selected, however the entries are not applied.
Trap Submenu
Here, you enter the IP addresses of up to 10 trap receivers. The
SCALANCE W 788 sends a trap to all the addresses you enter if their Enable trap
check boxes are selected.
Groups Submenu
This page displays the SNMPv3 groups. You can create a new group by clicking
the New button and specifying the group name, the security level, and the write or
read permissions.
You can delete a group by selecting the check box in the Del column and clicking
the Set Values button.
Users Submenu
This page displays the SNMPv3 users. You can create a new user by clicking the
New button and specifying the user name and the group to which the user will be-
long.
You can delete a user by selecting the check box in the Del column and clicking
the Set Values button.
Syntax of the Command Line Interface
CLI\SYSTEM\SNMP>
Command Description Comment
snmp <E|D>
Enables / disables SNMP.
Operating Instructions SCALANCE W 788-1pro / SCALANCE W 788-2pro
72 C79000-G8976-C184-01