User's Manual

Configuration Using Web Based Management and the Command Line Interface
Command Description Comment
snmpv1 <E|D>
Enables / disables SNMPv1/v2c.
snmpro <E|D>
Enables / disables SNMPv1/v2c
read only.
getcomm <Read community
string>
Specifies the Read community
string.
setcomm <Write community
string>
Specifies the Write community
string.
snmpv3 <E|D>
Enables / disables SNMPv3. The special features of
SNMPv3 undertake effect
after you disable
SNMPv1. Enabling
SNMPv3 does not auto-
matically disable
SNMPv1.
CLI\SYSTEM\SNMP\TRAP>
Command Description Comment
traps <E | D>
Enables / disables SNMP traps.
settrap <n> <IP address>
<E|D>
Specifies the IP address of the trap
recipient n (n between 1 and 10) and
enables / disables the sending of
traps to this recipient.
CLI\SYSTEM\SNMP\GROUP>
Command Description Comment
clearall
Deletes all SNMP groups.
CLI\SYSTEM\SNMP\USER>
Command Description Comment
clearall
Deletes all SNMP users.
6.2.8 SNTP Config Menu Command
Time-of-Day for Synchronization in the Network
SNTP is the acronym for Simple Network Time Protocol. An SNTP server uses this
protocol to provide a uniform time throughout the entire network. Clients can syn-
chronize themselves with this time.
If you enter the IP address of an SNTP server here and select the time zone of the
SCALANCE W 788, the SCALANCE W 788 uses the time information from the
server.
Operating Instructions SCALANCE W 788-1pro / SCALANCE W 788-2pro
C79000-G8976-C184-01
73