Specifications

Faults and what to do about them en

Information on the display

panel

Display Cause/Remedy

A:01 Close the door immediately because of the rising water level. If an interruption

occurs, A:01 and OPEn are displayed alternately.

A:02 The door is locked for safety reasons (water level and/or temperature too high).

■ Washing programme: In pause mode A:02 and PAUS are displayed alter-

nately. If you have to open the door, wait until the temperature has dropped

slightly or pump out the water (select e.g. Spin or Drain ).

■ Drying programme: If you have to open the door, wait until the temperature

has dropped slightly or set the drying programme to 15 min to cool down the

laundry.

If A:02 is frequently displayed at the end of the drying programme:

■ Clean the air filter. ~ Page 30

■ Run the Fluff Clean Ž (cold) programme without laundry.

A:03 Door cannot be locked/unlocked due to high temperature. Leave the washer dryer

switched on for about 1 min. The washer dryer can then be locked/unlocked again.

hot The door cannot be opened after the drying programme due to the high tempera-

ture. The cooling process continues until the display disappears, after which the

door can be opened.

| ■ Flashes (no water supply): Tap turned on? Water inlet filter blocked? Clean

the water inlet filter. ~ Page 29

Water hose kinked or blocked?

■ Lights up (low water pressure): For information only. This will not affect the

programme progress. The programme duration is extended.

E:18 Drain pump blocked; clean the drain pump. Clean the drainage hose

on the siphon.

ªªª ■ Hold down button Dry for 3 seconds to delete the display.

■ Clean the air filter. ~ Page 30

■ Run the Fluff Clean Ž (cold) programme without laundry.

LO kg, HI kg Laundry amount information. On when drying phase finished.

LO kg: Signals a small load for drying,

HI kg: Signals a very high load for drying.

Other displays Turn the programme selector to $ Off. The appliance is switched off. Wait 5 s and

switch on again. If the display is indicated again, call customer service.