User's Manual

Automation and Drives - SCE
T I A Training Document Page 61 of 129 Module
F6
Issued: 02/2008 Operator Control with WinCC flexible 2005
Preface Installation Project Description Step7 Project HMI Station WinCC flexible Projekt Messages Recipes User Management
6.3.3 Setting the Profibus DP Address
To set the Profibus DP address, click on “S7 Transfer Settings“ on the desktop.
Select Profibus and click on the button Properties.
Place the checkmark at “Panel is the only master on the bus“.
Assign the Profibus DP Address 1 and confirm with OK.
6.3.4 Assigning the Ethernet Address
On the desktop, operate the symbol
and select the Onboard LAN Ethernet Driver.
Click on the button Properties.
Here, you can make the settings for the Ethernet.