Use and Care Guide

Connector:

The connector (BB) aIready comes attached to the triangle fabric brush head (T) and the steamer

head (R). To connect the parts together, match the flat side of the connector (BB) tip to the

rectangular bump in the triangle fabric brush head (T) and steamer head (R). Push the connector

(BB) all the way in and turn 180 degrees for a tight fit. (If you purchase additional accessories, the

connector will need to be used on other parts in the same way.)

Extension Arm (s):

The extension arm (W) can be inserted into the trigger handle (A). You can attach the triangle

fabric brush head (T), angle concentrator (AA), cylinder roller (T), or steamer head (R) to the

extension arm (W) to help extend your reach.

Steamer Head/Floor Cloth Pad:

Set floor cloth pad (AA) on the ground with microfiber side down. Align self adhesive strips at the

bottom on the steamer head (R) with the floor cloth pad (AA). Place steamer head (R) on top of

floor cloth pad (AA) and apply pressure to assure hold. The steamer head (R) can be inserted into

extension arm (W).

Triangle Fabric Brush Head/Small Cloth Pad:

The triangle fabric brush head (T) can be inserted into the trigger handle (A) or extension arm (W)

using the connector (BB). Place small cloth pad (S) over the triangle fabric brush head (T).

Cylinder Roller/Cylinder Roller Pad:

The cylinder roller pad (Z) can be placed over the cylinder roller (Y) thru the open end on the

side. Secure the cylinder roller pad (Z) with drawstring.

Squeegee:

The squeegee (CC) connects onto the triangle fabric brush head (T) and can be used for mirrors

or windows. Insert the tabs on rear of the squeegee (CC) into the hooks located on the bottom

rear of the triangle fabric brush head (T) and firmIy snap the pieces together.

ASSEMBLY AND USE