Use and Care Manual

Angle Concentrator/Round Brush:

Attach the angle concentrator (AA) to the trigger handle (A) or extension arm (W). You can attach the

round brush (DD) or (EE) if you need additional scrubbing. Fit tip of concentrator into the end of the

round brush.

Drain sanitizer Nozzle:

The drain sanitizer nozzle (X) attaches to the angle concentrator (AA).

IMPORTANT: Make sure the accessory is pushed as far as possible onto tip to ensure the fit is sealed.

This will prevent steam from seeping out unwanted areas and prevent injury.

NOTE: The steamer does not require distilled water. Residents in areas with hard water should use

distilled water for better performance.

USE:

Before plugging in your steamer, unscrew the water tank cap (I). Use the refill cup (U) and funnel

(V) to fill water tank. You will only need to fill refill cup 3 times to fill tank. Screw water tank cap (I)

back onto the steamer body (L) firmly.

Place desired attachment onto trigger handle (A). To switch attachments, press attachment

release button (D) to remove attachment pieces from trigger handle (A).

Plug in steamer and turn power on/off button (K) on. A red power light (N) will illuminate to

indicate unit is working. Be sure desired attachments are already in place before you turn on

your steamer. Be sure steam trigger (C) is not Iocked while steamer is heating up.

A orange steam ready light (N) will illuminate when steamer is ready for use. The pressure gauge

(J) will be between 3-4 bars of pressure when ready. It may take several minutes. Press steam

trigger (C) and begin steaming. The pressure gauge (J) will maintain around 1 bar when steaming

continuously.

WARNING: BUILT UP PRESSURE IN THE STEAMER BODY WILL FORCE THE STEAM OUT WITH

MORE FORCE THAN IT WOULD NORMALLY WHEN TRIGGER IS INITIALLY PRESSED. BE SURE TO

INITIALLY AIM THE STEAM NOZZLE AT A SINK OR INTO THE AIR WHERE NO PERSON OR OBJECT IS

STANDING.

The steam trigger will immediately begin steaming in constant steam mode. To stop emitting

steam, slide trigger release switch (B).