Aqua Laser, Aqua Pro, Aqua Pro V Steam Mop SSM-0618 SSM-3618 SSM-4618 INSTRUCTION MANUAL
INTRODUCTION Thank you for choosing Sienna for your household cleaning needs. Our floor care products use the active power of steam without the use of chemicals; making it a green product that is safe for the ecosystem. You have begun the first step into transforming your house into a green, environmentally safe home. Our Sienna steam products are a modern way of cleaning that is efficient and far more sanitary than conventional methods.
SAFETY GUIDELINES The Sienna Aqua Laser (SSM-0618), Aqua Pro (SSM-3618), and Aqua Pro V (SSM-4618) Steam Mops are for indoor domestic floor use only. Any commercial use will void warranty. The steamer(s) should not be used upside down or vertically. They are designed for sanitizing and cleaning an array of floor surfaces such as carpet, ceramic tile, marble, sealed hardwood, sealed laminate, stone and vinyl floors.
KEY FEATURES A. TRIGGER B. HANDLE CORD WRAP C. HANDLE D. FOLDING HANDLE BUTTON E. CARRYING HANDLE F. LED G. STEAM CONTROL (Aqua Pro & Aqua Pro V) H. VIBRATE (Aqua Pro V) I. WATER TANK RELEASE LOCK J. WATER TANK K. FILTER L. STEAMER BODY M. STEAMER HEAD N. CARPET GLIDER O. QUICK RELEASE CORD WRAP P. POWER CORD Q. LOWER CORD WRAP R. SCREW S.
ASSEMBLY AND USE 1) Attach steamer head to body of the unit. 2) Secure steamer head with screw provided until fully tightened (use Philips screwdriver.) 3) Push the steamer handle straight up by pressing on the folding handle button. 4) Set cloth pad on the floor. Be sure to loosen drawstring on the pad so that the steamer head will fit properly inside the pad. Place steamer head onto cloth pad so that steamer head is sitting inside pad.
NOTE: The steamer does not require distilled water. Residents in areas with hard water should used distilled water for better performance. 6) Twist the quick release cord wrap clockwise to un-wrap the power cord completely. Hang the cord on the handle cord wrap for better use of the steamer when moving and cleaning. Be sure to plug unit into a grounded outlet. 7) The LED will illuminate when the steamer is ready for cleaning (Aqua Laser only).
11) When steamer stops emitting steam, after approximately 15 to 20 minutes of use, simply remove the water tank, refill, and continue cleaning. WARNING: NEVER RUN THE STEAMER WITHOUT WATER. 12) When you finish cleaning, unplug power cord from outlet. Be sure to empty water tank and carefully remove cloth pad from steamer head. Store the unit upright in a dry area or hang it by the storage hook. CAUTION: The cloth pad may be very hot.
TROUBLESHOOTING CAUTION: Prior to cleaning or maintaining your steam mop, isolate the unit by removing the cord from the power socket. PROBLEM LED is not on SOLUTION = = = = No steam = = Pale residue left on floor = = Ensure steamer power cord is correctly plugged into a 120V AC power outlet only. Ensure circuit breaker is operational. Try operating steamer from another power outlet. If unit is still not working, call customer service at 1-888-574-3662. Ensure water tank is full.
ONE YEAR LIMITED WARRANTY Our Sienna product warranty extends only to the original customer purchaser of the product. It is warranted by the manufacturer to be free from all defects in materials or workmanship for a period of one year from the date of original purchase. This warranty is subject to the following conditions, exclusions and exceptions.
Customer Service will give you further instructions for returning a defective product for repair or replacement. When returning a defective product, carefully pack the item to avoid damage in shipping, the manufacturer cannot assume responsibility for loss or damage during incoming shipment. We recommend that you insure the package, as damage in shipping including the shipping cost is not covered under our warranty.