Use and Care Manual

ASSEMBLY AND USE

1) Set press on a ﬂ at, level surface.

Warning: The automatic vacuum suction will force the air thru the ironing

board and out the back of the press leaving your surface area moist and

wet. It is recommended that you place the press on a surface that will not

be affected by the moisture. For example, avoid using press on wood or

laminate surfaces where the steam and moisture may damage the ﬁ nish.

NOTE: It is recommended to use a pressing stand when using your steam press.

2) Gently press handle (I) down, turn locking knob (B) to “unlock” position, then lift

handle (I) to open press. The press will automatically stay in lifted position.

3) Before plugging in the press, ﬁ ll the water tank (N) using the water container (O)

provided. Slide the water tank (N) forward and pouring the water into the holes

of the tank. When ﬁ nished, slide the tank back into place. Water is only necessary

when using steam burst button (J).

NOTE: When filling the water tank, distilled water is preferred, but not necessary.

NOTE: The water tank is not removable. It is designed to store any left over water

from use. Do not attempt to force it free.

4) Plug in and press power on/off button (E) located on the LED digital touch screen

control panel. A power on indicator light (H) will appear. Be sure pressing plate (K)

is in open position when unit is initially turned on.

5) Use fabric temperature selection arrows (A) to choose fabric setting. It may take a

few minutes to reach chosen temperature when decreasing or increasing settings.

NOTE: It takes approximately 12 minutes for the press to reach the linen temperature.