Use and Care Manual

7
10) Use adjustable steam control dial (C) to control the amount of steam, low to high,
you use.
CAUTION: Do not hold down press for longer than 5 seconds. If using
steam burst button, do not fully close press down onto fabric. If you hold
down the press for too long, you may cause your garments to wrinkle because
they are too hot. If this should happen, spray down garment with water and
start over.
CAUTION: When using steam, do not hold steam button for longer than
3 seconds. If steam is used for too long, you will cause the press to drop
dramatically in temperature and will have to wait for it to reach the initial
desired setting. The drop in temperature cannot be avoided as the burst
of steam cools down the pressing plate instantly. By using steam in short
bursts, you will help to eliminate the dramatic temperature drop and thus
be able to press quicker and more effi ciently.
Auto Shut-off and Auto Wake-Up:
E1: A warning beep will signal if the pressing plate is left in a closed position against
the ironing board for more than 10 seconds. The press will stop heating and the auto
shut-off feature will initiate unless the pressing plate is restored to the lifted position.
The auto wake-up feature will then kick in. In some cases, you will need to either turn
press off and then on again or unplug then re-plug the unit in to reset function.
CAUTION: Do not lock pressing plate and ironing board together as press
will begin to beep. Only lock when storing.
E2: A warning beep will signal if the press is left unattended without use for approximately
20 minutes. The press will stop heating and auto shut-off feature will engage. In order
to restore use, simply press on/off button or press temperature control buttons to reset
press.
E3: A warning beep caused by a loose thermostat inside the machine.
CAUTION: If the E3 warning occurs, unplug your press and call customer
service for warranty assistance.
Warning: During initial use or after a long period of time without use, press
the steam burst button continuously for several seconds to clear pressing
9