Specifications

Sierra Pacific Innovations Corp 1.3.2
M1-D User’s Guide 17
IRIS OPEN – The [IRIS OPEN] command (typically labelled as
[OPEN] on keyboard controllers) is used to control the thermal
imaging sensor zoom.
IRIS CLOSE – The [IRIS CLOSE] command (typically labelled
as [CLOSE] on keyboard controllers) is used to control the
thermal imaging sensor color palletes.
FOCUS FAR – The [FOCUS FAR] command (typically labelled
as [FAR] on keyboard controllers) is used to activate the laser
pointer.
FOCUS NEAR – The [FOCUS NEAR] command (typically
labelled as [NEAR] on keyboard controllers) is used switch
between the visible and thermal imaging sensors.
Power On the M1-D
To power on the M1-D you need to connect power to the system
by plugging in the cigarette lighter vehicle adapter. If you have
installed a remote power switch use that to turn on the system.
Once turned on the M1-D will begin its self test routine. You will
see the unit spin and tilt as it runs the self test. Once it stops
moving the M1-D will be ready for operation.
Pan Tilt The M1-D
Using a joystick controller you can remotely position the M1-D in
the pan and tilt access by using the joystick on your control
keyboard. Pushing the joystick to the right will cause the unit to
pan to the right. Pushing the joystick up will cause it to tilt
upward. You can invert these operations with a special menu
command (see Advanced Settings Menu Preset Commands).
Select Video Source
The M1-D has both a thermal imaging sensor and a visual light
sensor. Video is output from the M1-D via a single video line. By
sending a command to the M1-D you can switch between the