Specifications

Sierra Pacific Innovations Corp 1.3.2
M1-D User’s Guide 31
Setting Preset Positions
The M1-D allows you to “preset” positions of the system for
either direct recall or for use in Auto Scan or Pattern Scan
features. The M1-D can maintain up to 80 preset postions
(Presets 0-79). Please refer to the Preset Call Number Code
Table 1.5 for information on which prests are used with Auto
Scan and Pattern Scan. To set a preset on typical keyboard
controllers use the following syntax. [SET] + ## + [ENTER].
Keyboard controllers vary so the exact syntax may differ. On
some controllers the syntax may be [PRESET] + ## + [ENTER].
Contact SPI Corp for assistance 702-369-3966.
Calling Preset Positions
The M1-D is capable of remembering up to 80 preset positions
(Presets 0-79). These positions can be instantly recalled using
the PELCO-D commands for CALL or PRESET. These
commands are typically labelled [CALL] [PRESET] [PRE] on
most keyboard controllers. The typical syntax for calling a preset
postion is [CALL] + ## or [PRESET] + ##. This can vary with
your keyboard controller and you may have to input ## + [CALL]
or [PRE] + [ENTER]. Presets are also used for advanced preset
call number codes during Auto Scan and Pattern Scan functions
as outlined in the Preset Call Number Code Table 1.5. Contact
SPI CORP for technical assistance with presets 702-369-3966.
Advanced Preset Call Number Codes
The M1-D utilizes custom preset call number codes to trigger
advanced operation of the system. These commands can be
sent to the system via Pelco-D protocol or via keyboard
controller. Cades are triggered by utilizing the CALL or PRESET
(depending on your keyboard) buttons. The typical syntax for
entering the commands is
CALL + ## + ENTER or PRESET + ## + ENTER