OWNER’S MANUAL Important! Read all instructions and warnings in this manual and your firearm’s manual before using your Remington® 2020™
Batteries Congratulations on your purchase of the Remington 2020 Digital Optic System (DOS), the greatest advance in targeting, tracking, and ballistic computing since telescopic sights were introduced. Combining the capabilities and functionality of multiple devices into one package, the Remington 2020 allows you to immediately improve your accuracy and confidence at distances up to 500 yards. Charging batteries Fully charge batteries before first use.
Remington 2020 Overview Remington 2020 Digital Optic System (DOS) Heads UP Display (HUD) Note: The Remington 2020 has been designed and built to be water-resistant and handle all reasonable and foreseeable hunting conditions. Never submerge the unit in water. If the unit becomes exposed to excessive moisture, wipe it dry immediately. Warning! No user maintenance or service is required inside the product. If service is required, return the product to the manufacturer.
Operating your Remington 2020 Power Button Wind Input Rocker (Advanced Modes only) Press the Power button to turn on the digital optic system. Shooter MUST assess wind conditions, and input if necessary prior to making a TTR shot. Power button LED and HUD will turn on. Note: The Remington 2020 will boot up in Traditional mode within 2 seconds. It may take up to 15 seconds before all buttons are active and Advanced modes can be selected.
Operating your Remington 2020 Sun Shield • Daylight The front sun shield is designed to reduce glare and is required for optimal daytime use. • Dawn/Dusk The front sun shield contains a cut filter that, when removed, will enhance visibility in very low light conditions, generally around dawn and dusk. If the HUD image becomes RED after removing sun shield, the available light is too bright and the sun shield should be re-attached.
Operating your Remington 2020 Ammunition You MUST configure the Remington 2020 to the correct Remington ammunition you are using at any given time. Ammunition can be set using the HUD Console or the Settings feature in the Remington 2020 App. Use only Remington ammunition types specifically paired with your Remington 2020 as shown in the table below. All Remington 2020 systems have been designed and characterized using these types and are programmed with the ballistic solutions for those loads.
Firing Procedure Traditional Note: Use the blue ellipse to aim at the target you want to range. The ellipse and reticle are not aligned because the laser range finder (LRF) is aligned with the digital image sensor whereas the Mil-dot reticle is aligned with the bore at a 100 yard ballistic solution for the selected ammunition. This effect is shown in the example to the right. Traditional mode displays a Mil-dot reticle centered at a fixed 100 yard zero.
Firing Procedure continued Remington 2020 Apps Under certain conditions you may see the following messages or graphics appear in the HUD. HUD messages No Target Found You may see this message if your target is camouflaged by surroundings or laser cannot return range due to environmental conditions such as fog or smoke. Remington 2020 The Remington 2020 App is the primary tool for communicating with and configuring your Remington 2020 Digital Optic System.
Remington 2020 Apps continued ShotView Zeroing Adjustments Use to adjust reticle Up, Down, Left, and Right. Record Videos Settings ShotView is a TrackingPoint™ App that enables anyone to share and collaborate in the shooting experience in real time by live streaming everything the shooter sees in the Heads Up Display to a smart device. Use to turn On or Off automatic video recording when the tag button is pressed.
connecting Apps to 2020 Downloading Apps to New Devices Cleaning Lenses Devices supported Clean lenses carefully using a lens brush first to remove dust followed by a cotton swab with distilled water, pure alcohol, or a high quality glass cleaner. You will need either an Apple iOS or Android device to use Remington 2020 and TrackingPoint Apps. Apple iOS 1. Access the App Store on your mobile device or through iTunes. 2.
Remington is a Trademark Registered in the United States Patent and Trademark Office By Remington Arms Company, LLC. Printed in the U.S.A.