Specifications
142 SIERRA ST., EL SEGUNDO, CA 90245 (310)322-2136 FAX (310)322-8127 www.ESE-WEB.com
7
VIDEO DISTRIBUTION AMPLIFIERS
ESE offers several DAs that operate with standard NTSC or PAL video signals. Described below
are the ES-207A (1x4), ES-208 (1x12) and ES-247E (Quad 1x6). The “Audio Counterparts” to
the ES-207A and the ES-247E are described on page 5.
The ES-247E is a quad 6 output Video Distribution Amplifier housed in a traditional rack mount
enclosure. Meanwhile, the ES-207A and ES-208 Video Distribution Amplifiers answer the “one
more unit” question with a versatile little package that can be stashed most anywhere, either
temporarily or permanently. Controls are accessible with a miniature screwdriver through
the front panel/top plate for Video Gain, HF Equalization and, in the case of the ES-208, DC
Level. A single pair of BNC connectors are wired for a loop through input.
Features:
• Ruggedized Enclosure • Video Gain & EQ Controls • Loop-thru Input
• Equalization For Up To 1000’ of RG-59 Cable
• Broadcast Quality Distribution
• DC Coupling Available
• Recessed Controls
These amplifiers can be used for distribution and for signal conditioning, with the EQ control equalizing up to
1000 feet of RG-59 coaxial cable. A very wide range of chroma level adjustment can be obtained with the
Gain control. The ES-208’s output video should be set for 0 VDC (using the DC control) on the blanking or
porch level, with video extending positive and sync negative.
Specifications
ES-207A ES-208 ES-247E
Input: 1 Vpp 1 Vpp 1 Vpp
Source: 75Ω 75Ω 75Ω
Response: 10 Hz - 10 MHz, +/-1dB 10 Hz - 10 MHz, +/-1dB 10 Hz - 10 MHz, +/-1dB
Equalization: 1000’ of RG-59 1000’ of RG-59 1000’ of RG-59
Gain: -2dB to +3dB -2dB to +3dB -2dB to +3dB
S/N Ratio: 62dB 62dB 62dB
Output Isolation: 45dB 45dB 45dB
Differential Gain: <.2% <.2% <.2%
Differential Phase: < .2
0
< .2
0
< .2
0
Propagation Delay: 5ηs 100ηs 5ηs
Gain Controls: One One Four (one per input)
Output Level: 1 Vpp 1 Vpp 1 Vpp
Connectors: BNC BNC BNC
Enclosure: Die-cast Orange Box Die-cast Orange Box Rack Mount
Dimensions: 4.7” x 3.7” x 2.2” 7.3” x 4.7” x 2.2” 1.75” x 19” x 5”
Electrical: 117 VAC, 50/60 Hz 117 VAC, 50/60 Hz 117 VAC, 50/60 Hz
Power Required: 3 Watts 3 Watts 10 Watts
Options: J, UL J, UL J, UL
ES-247E
ES-247E (Rear View)
ES-207A
ES-208










