User`s manual

SHASTA HD 88 HD/SDI 3G ROUTING SWITCHER

**W1,17,3,9!!

says that connections are to be made on level 1: from input 17 to output 1, input 3 to

output 2, and input 9 to output 3.

If the level number is specified as "0", this means that the connection is to be made on all

levels (AFV).

For example, the command:

**W0,8,3,7!!

says that connections are to be made on all levels: from input 8 to output 1, input 3 to

output 2, and input 7 to output 3.

An input number of 0 means the output connection is to be left unchanged.

An input number of ë-ë (dash) means the output is to be disconnected. If the router does

not support disconnected outputs, the output connection will be left unchanged.

It is an error to request connection of an input or output that doesn’t exist on the specified

level, even if the input or output does exist on some other level. However, if the level

number is “0”, any input or output may be used as long as it exists on at least one level,

and in that case no connection will be made on any level on which the input and output

does not exist. If the requested connection has an output or input number that isn’t

mapped to a physical connector (on virtual-mapped routers) on one or more levels, those

levels are simply not changed.

If “U2” is in effect (see “U” command), the response will include one or more V, Y, or X

commands to report the new status of the outputs. The response will be the same as if

“O” commands were issued for the outputs immediately following the “W” command. No

response is generated if this command is being used to define a salvo.

“X”: Connect Crosspoint

Use command X to request that a connection be made. It must be followed by an output

number, a comma, an input number, a comma, and a level number. For example:

**X8, 3, 2!!

This string says that a connection is to be made between output 8 and input 3 on level 2.

If the level number is specified as “0”, this means that the connection is to be made on all

levels (AFV). For example, the command:

**X8, 3, 0!!

This string says that a connection is to be made between output 8 and input 3 on all

levels.

“Y”: Connect AFV

Use command Y to request that a connection be made. It must be followed by an output

number, a comma, and an input number. The connection is made on all levels (AFV). For

example, the command:

**Y2, 8!!

This string says that input 8 is to be connected to output 2 on all levels.

“Z”: Connect AFV

The command "Z" is used to request that a connection be made. It must be followed by a

comma-separated list of input numbers, one for each output, up to the number of outputs