User`s manual

SHASTA HD 88 HD/SDI 3G ROUTING SWITCHER

Commonly Used Switching Commands

This section contains the most commonly used switching commands. These commands

are explained in detail in the proceeding section and are merely meant as a “short cut” for

programmers.

“Y” Command- All Levels

The “Y” command switches all levels (i.e. video and audio).

For example;

**Y2,8!!

This string says that input 8 is to be connected to output 2 on all levels.

“X” Command- Specify Levels

Using the “X” command requires that a level is specified.

For example;

**X8, 3, 2!!

This string says that a connection is to be made between output 8 and input 3 on level 2.

If a level number of “0” is used, all levels are switched.

“V” Command- Connect Levels

The “V” command is followed by an output number, a comma, and an input number for

each level, up to the number of levels on the router.

For example;

**V12, 7, 8, 9!!

This string says that connections are to be made to output 12 from input 7 on level 1,

input 8 on level 2, and input 9 on level 3.