User`s manual

SIERRA VIDEO

Troubleshooting

Introduction

NOTES:

If the output signal is disturbed or interrupted by electromagnetic interference, the signal

should return and stabilize when the interference ends. If not, turn the power switch off

and on again to reset the switcher.

If the following recommended actions still do not result in satisfactory operation, please

consult your Sierra Video Dealer.

Power and Indicators

Problem Remedy

No power  Confirm that the rocker switch is in the “ON” position, and that the power

lamp is illuminated.

 Confirm that power connections are secured at the switcher and at the

receptacle. Make sure the receptacle is active, with the proper mains

voltage.

 If there is still no power, check the fuse. Remove power cord from the AC

outlet and from the switcher and then remove the fuse holder located

above the power connector. Confirm that the fuse is good by looking at

the fuse wire connected to the ends of the fuse. If the wire is separated,

replace the fuse.

Chapter