Manual

Global Positioning System (GPS)
Rev 3.0B Feb.08 103
Note: Unlike standard TAIP which simply sends to the last client to
request automatic reports, the remote reports are sent to the desti
-
nation address (*PPIP) and destination port (*PPPORT).
b. SettheGPSReportType,*PPGPSR,toyourpreferred
TAIPdataformat.
Figure 10-35: AceManager : PinPoint - *PPGPRSR
• F0‐TAIPdata(LN):latitude,longitude,altitude,the
horizontalandverticalspeed,andheading.
• F1‐CompactTAIPdata(PV):latitude/longitude,speed,
andheading.
Local Connection
SomeTAIPclientapplicationscansendTAIPrequestsand
listenforreportsusingalocalconnection.Generallythisis
doneover theserialportusingPPP.Thiscanalsobedoneover
theUSBvirtualserialportusingPPP.
ThePinPointXwilllistenforTAIPrequestsonthelocalIP
addressandport.OnceaTAIPrequestcommandhasbeen
received,thePinPointXtwillbeginissuingTAIPreportstothe
localIPaddressandport21000.Theclientapplicationshould
belisteningforreportsonthisIPaddress
andport.No
unsolicitedreportswillbesentfromthePinPointtothelocal
clientapplication.
ToconfigurethislocalTAIPreporting,youwillneedtoset
fourcommands:*PPIP,S53,*PPGPSR,and*PPLATS.
a. Settheport(S53)tothelocalporttowhichyouwant
thereportssent,21000isthecommonsetting.S53,in
AceManager, ispartoftheMiscgroup.