Manual

Configuration Commands
Rev 3.0B Feb.08 128
S5=n
Thisregistersetsthecharacterrecognizedasabackspace
duringcommandentry.CannotbeconfiguredinAceManager.
• n=0‐127(ASCIIcharacternumber)
S6=n
Thisregisterdenotesthewaittime,inseconds,beforeablind
dial(nodialtonedetection).Cannotbeconfiguredin
AceManager.
• n=2‐10seconds
S8=n
Wheneveradialcommandcontainsthecommacharacter,the
contentsofthisregisterspecifythepausetimeforeachcomma.
CannotbeconfiguredinAceManager.
• n=0‐255
S9=n
Specifiesthetimethatthereceivedcarriermustbepresentfor
themodemtorecognizeitandturnonDataCarrierDetect
(DCD)ifapplicable.Theim plementation isentirelyattheIWF
modem.CannotbeconfiguredinAceManager.
• n=0‐255
S10=n
Specifiestheamountoftimethatthecarrierfromtheremote
modemcanbelostbeforethemodemgoeson‐hook.This
allowstemporarydisruptionstocarrierwithoutdisconnecting.
Asettingof255causesthemodemtodisableCarrierDetect
andpresumecarrierisalwayspresent.Cannotbeconfigured
inAceManager.
• n=1‐2545
S23=[speed],[databits][parity][stop bits]
Seriallineparameters.Thesettingstakeaffectafterreset.
• speed=300|1200|2400|4800|9600|19200|38400|
57600|115200|230400
• databits=7or8(DatabitsMUSTbe8databitsforPPP
mode.)
• parity=O:Odd
• parity=E:Even
• parity=N:None
• parity=M:Mark
• stopbits=1|1.5|2