Manual

Data Communication and Host Modes
Rev 3.0B Feb.08 62
Figure 8-1: AceManager : UDP - MD
IftheserialportofthePinPointXisinanymodeotherthanAT
orPassThru,theATcommandmodecanbere‐enteredby:
• DeactivatingDTR(if&D2orIgnoreDTR,S211,isnotset).
• Issuingthe+++escapesequence(ifDisableATEscape,
DAE,isnotset).
• ResettingorPowercyclingthemodem.
Note: DTR needs to be asserted (S211=1 or &D0) by the host before
PPP Mode, SLIP Mode, UDP PAD Mode, or TCP PAD Mode can be
entered.
AT Mode
Usingaterminalconnection,ATcommandsareusedto
configurethemodem,commandittodosomething,orquerya
setting.ForafulllistingoftheATcommands,refertothe
appendix.AceManagerisagraphicaluserinterfaceformost
ATCommands.
• ATcommandsmust alwaysbeterminatedby<CR>(ASCII
character0x0D),acarriagereturn(pressingenteronthe
keyboard).Somemayalsoincludeanewlineorlinefeed
<LF>.
• IfE=1(EchoOn),theATcommand(includingthetermi‐
nating<carriagereturn)willbedisplayed(output)before
anyresponses.
• TwosettingsaffecttheformatofATcommandoutput:V
(Verbose)andQ(Quiet).
• IfQ=1(QuietOn),noresultcodesareoutputwhatsoever,
sothereisnoresponsegeneratedbya(nonquery)
command.
• IfQ=0(QuietOff),resultcodesareoutput.Theformatof
thisoutputisthenaffectedbytheVerbosesetting.