User's Manual
Table Of Contents
- ChapterTitle - 1: Introducing the AirCard®700 Series Wireless Network Cards
- ChapterTitle - 2: The SIM Card and Your Account
- ChapterTitle - 3: Installation on Notebook PCs
- ChapterTitle - 4: Installation on Devices Running Windows CE
- ChapterTitle - 5: Configuring Your Account
- ChapterTitle - 6: Care and Maintenance of Your Network Card
- ChapterTitle - 7: Watcher™ Basics
- ChapterTitle - 8: Technical Specifications
- ChapterTitle - 9: Regulatory and Safety Information
AirCard 700 Series Installation Guide
20 2130204CEFCC
attached, attach it. (See page 15.) With the label facing up,
insert the AirCard into your PC Card slot:
Note: Do not forcefully insert the
AirCard. This may damage
connector pins. If you have more
than one PC Card slot, you may
obtain better signal strength
using the top slot.
Figure 3-2: Inserting the AirCard
Windows detects that a new device has been inserted and
launches a wizard that guides you through the driver
installation.
7. On the first window of the Found New Hardware Wizard,
select
Install the software automatically (Recommended) and
click
Next.
8. If the Software Installation window appears, click Continue
Anyway
.
9. Click Finish and repeat steps 7 to 9 as prompted.
10. Click OK when notified that the AirCard has been success-
fully installed.
Watcher should launch automatically when the AirCard is
inserted. If your AirCard has not yet been configured to use
your account, you are prompted to do so. See “Setting up a
profile” on page 36.
To close the CD start-up menu, click Demoshield on the
Taskbar, then use the
exit option in the lower right corner of
the window.