User guide

Serial Configuration
Rev 2.0 C Aug.10 107
Figure 10-2: ACEmanager: Serial - Port Configuration (Raven line devices only)
Command Description
TCP Auto Answer This register determines how the MP device responds to an incoming TCP connection
request. The MP device remains in AT Command mode until a connection request is
received. DTR must be asserted (S211=1 or &D0) and the MP device must be set for a
successful TCP connection. The MP device will send a “RING” string to the host. A
“CONNECT” sent to the host indicates acknowledgement of the connection request and the
TCP session is established.
• n=0 : Off (Default).
• n=1 : On.
• n=2 : Use Telnet server mode on TCP connections.
• n=3 : With a Telnet connection, overrides the client's default echo, allowing the server
on the host port to perform the echo. CRLF sequences from the telnet client will also
be edited to simply pass CRs to the server on the host port.
TCP Connect Timeout Specifies the number of seconds to wait for a TCP connection to be established when
dialing out.
TCP Idle Timeout Interval to terminate a TCP connection when no in or outbound traffic. This value affects
only the TCP connection in TCP PAD mode.
• n=interval
TCP Idle Timeout
Secs
TCP connection time-out (TCPS) units. Specifies a time interval upon which if there is no in
or outbound traffic through a TCP connection, the connection will be terminated.
• n=0 : minutes
TCP Connect
Response Delay
Connect Delay: Number of seconds to delay the “CONNECT' response upon establishing a
TCP connection. OR Number of tenths of seconds to delay before outputting ENQ on the
serial port after the CONNECT when the ENQ feature is enabled.
• n=0 - 255