User guide
Serial Configuration
Rev 2.0 C Aug.10 109
Allow Any Incoming
IP
Allow IP address.
• n=0 : Allow only the IP address specified in S53 to connect when UDP auto answer is
enabled (S82=2).
• n=1 : Allow any incoming IP address to connect when UDP auto answer is enabled
(S82=2).
Always subject to any Friends filters that may be defined.
Allow All UDP Accepts UDP packets from any IP address when a UDP session is active. If there is no
UDP session active, an incoming UDP packet will be treated according to the UDP auto
answer and AIP settings.
• n=0 : No effect (Default).
• n=1 : Accept UDP data from all IP addresses when in a UDP session.
UDP Auto Answer
Response
Half-Open Response - In UDP auto answer (half-open) mode.
• n=0 : No response codes when UDP session is initiated.
• n=1 : RING CONNECT response codes sent out serial link before the data from the
first UDP packet.
Note: Quiet Mode must be Off.
Dial UDP Always The dial command always uses UDP, even when using ATDT.
• n=0 : Dial using the means specified (default).
• n=1 : Dial UDP always, even when using ATDT.
Note: When this parameter is set you cannot establish a TCP PAD connection.
UDP Serial Delay Waits the specified delay before sending the first UDP packet and the subsequent UDP
packets out to the port Ethernet.
• n=0 : No UDP packet delay (Default).
• n=1 - 255 : Delay in 100ms units, from 100 ms to 25.5 sec.
Command Description
Command Description
Host Authentication
Mode
Host Authentication Mode: Use PAP or CHAP to request the user login and password
during PPP or CHAP negotiation on the host connection. The username and password set
in *HOSTUID and *HOSTPW will be used.
• Disable PAP or CHAP request (Default)
• PAP and CHAP
• CHAP
PPP User ID Host User ID for PAP or CHAP.
• user id (up to 64 bytes)
PPP Password Host Password for PAP or CHAP.