User guide
Rev 2.0 C Aug.10 203
GPRS Info
*NETSTATE? The current network state:
• Connecting To Network: The device is in the process of trying to connect
to the cellular network.
• Network Authentication Fail: Authentication to the cellular network has
failed. Verify settings to activate the device.
Data Connection Failed: The device failed to connect, and it is now waiting a
set time interval before it attempts to reconnect. Verify settings to activate the
device.
• Network Negotiation Fail: Network connection negotiation failed. This is
usually temporary and often clears up during a subsequent attempt.
• Network Ready: The device is connected to the 1x cellular network and
ready to send data.
• Network Dormant: The MP is connected to the 1x cellular network, but
the link is dormant. It will be woken up when data is sent or received.
• No Service: There is no cellular network detected.
• Hardware Reset: The internal module is being reset. This is a temporary
state.
*NETCHAN? The current active CDMA/GSM channel number.
*HOSTMODE? The current host mode (AT, PPP, UDP, etc.). If the device is not in AT mode,
telnet into the device to execute this command.
*NETERR? The EVDO or CDMA network frame error rate.
The EDGE or GPRS network bit error rate.
The network frame for CDMA or EV-DO or bit error rate for EDGE or GPRS.
*NETSERV? The type of service being used by the device, for example Tech EV-DO Rev
A or HSDPA.
Table 6-2: Status: Network
Command Description
Table 6-3: Status: GPRS Info
Command Description
*NETOP The current cellular carrier from the device's firmware.
Subscriber Identity Module ID. GPRS or EDGE Only.
+CIMI Subscriber Identity Module ID.
Current Cell Info Information. GPRS or EDGE Only.