User guide

Rev 2.0 C Aug.10 217
*MSCIUPDPERIOD Device Status Update Period - where n defines the update period in seconds.
• n=0 : Disabled
• n=1-255 seconds
DAE AT Escape Sequence detection.
• n=0 : Enable
• n=1 : Disable
*DATZ Enables or disables reset on ATZ.
• n=0 : Normal Reset (Default).
• n=1 : Disable Reset on ATZ.
*SNMPPORT This controls which port the SNMP Agent listens on.
• n=0 : SNMP is disabled
• n=1-65535
*SNMPSECLVL Selects the security level requirements for SNMP communications.
• n=0 : No security required. SNMPv2c and SNMPv3 communications are
allowed.
• n=1 : Authentication equivalent to “authNoPriv” setting in SNMPv3. SNMPv3
is required to do authentication, SNMPv2c transmissions will be silently
discarded.
• n=2 : Authentication and encryption, equivalent to “authPriv”' setting in
SNMPv3. SNMPv3 is required to do authentication and encryption, SNMPv2c
and SNMPv3 authNoPriv transmissions will be silently discarded. Messages
are both authenticated and encrypted to prevent a hacker from viewing its
contents.
*SNMPTRAPDEST Controls destination for SNMP Trap messages. If port is 0 or host is empty, traps
are disabled. Traps are sent out according to the SNMP security level (i.e. if the
security level is 2, traps will be authenticated and encrypted). Currently, the only
trap that can be generated is linkup.
• host=IP address
• port=TCP port
*SNMPCOMMUNITY The SNMP Community String acts like a password to limit access to the device’s
SNMP data.
• string =string of no more than 20 characters (default = public).
Table 6-16: Common: Other
Command Description