User guide

ALEOS User Guide
218 20080616
Low Power
Firewall
Table 6-17: Common: Low Power
Command Description
VLTG Set or query the voltage level at which the device goes into low power mode.
• n=0 : Ignore voltage for power control.
• n=threshhold in tenths of volts
Example: ATVLTG=130 would place the device in a low power use, standby
state if the voltage goes below 13.0V.
PTMR Number of minutes after one of the power down events (VTLG or DTRP)
happens until the device enters the low power mode. If DTRP and VLTG are
both 0 (zero), this setting does nothing.
• n=0-255 minutes
Note: There is always a minimum of 1 minute between power down event
and actual shutdown (to give the device time to prepare); entering zero will
not power down the device immediately, but after one minute.In the first 5
minutes after device powers up, power down events are ignored to give the
user time to change configurations.
SISE Standby Ignition Sense Enable: the device will monitor the ignition sense on
the power connector and enter the low power consumption stand-by mode
when the ignition is turned-off.
• n=0 : Disable
• n=1 : Enable
Table 6-18: Common: Firewall
Command Description
FM Firewall mode - Only allow specified IPs to access the device.
• n=0 : Disable Firewall mode
• n=1 : Enable Firewall mode - Only packets from friends will be accepted,
packets from other IP addresses are ignored.