User guide

ALEOS User Guide
220 20080616
Caution: Logging is intended for diagnostic purposes only. Extensive use of logging
features can cause degraded device performance.
GPS
This group includes commands specific to GPS features and the device line.
*DBGETHLVL Sets the logging level for the Ethernet port.
• n=0 : No logging
• n=1 : Log errors: invalid/corrupt packets, etc.
• n=2 : Log the header of all received packets. Note that this can quickly
exhaust available space for the event log.
*DBGDHCPLVL Enable or disable internal DHCP logging.
• n=0 : No logging
• n=1 : Log DHCP events.
Table 6-19: Logging
Command Description
Table 6-20: GPS: Server 1
Command Description
*PPIP IP address where GPS reports are sent (ATS Server IP). Also see *PPPORT.
• d.d.d.d=IP address
Example:
AT*PPIP=192.100.100.100
*PPPORT Port where GPS reports are sent.
• n=1-65535
*PPTIME GPS Report Time Interval. See also *PPMINTIME, *PPTSV, +CTA.
n=seconds (1 - 65535)
Note: Your cellular carrier may impose a minimum transmit time.
Caution: A report time of less than 30 seconds can possibly keep an RF link
up continuously. This will eventually cause the MP to overheat and shutdown.
An RF resource may continue be tied up to transfer small amounts of data.
Generally the RF channel will be released and go dormant in 10-20 seconds
of no data sent or received.
*PPDIST GPS Report Distance Interval in 100 Meter Units (kilometer). 1 mile is
approximately 1600 kilometers.
• n=0 : Disabled
• n=1-65535