User guide

ALEOS User Guide
226 20080616
Cellular
This group includes commands specific to HSDPA, EDGE and GPRS. If you are
not connecting to a which uses HSDPA, EDGE, or GPRS, you will not see this
group in the menu.
Table 6-23: Cellular
Command Description
*NETAPN Easy entry of the APN. If left blank, the device will attempt to use the default
subscriber value as defined by the account.
• apn=access point name
1 and “IP”, are required and not variable. Quotes need to be placed around the
APN.
Tip: When *NETAPN has been configured, +CGDONT will be pre-populated in
ACEmanager .
*RXDIVERSITY This is the diversity setting, It is Disabled by default.
+COPS Manually specify an operator. Refer also to *NETOP.
• mode=0 : Automatic - any affiliated carrier [default].
• mode=1 : Manual - use only the operator <oper> specified.
• mode=4 : Manual/Automatic - if manual selection fails, goes to automatic
mode.
• format=0 : Alphanumeric ("name") (G3x10 must use this format).
• format=2 : Numeric
• oper=”name”
+CGQREQ Set Quality of Service Profile. Change should be at carrier's request. Normally not
required to be changed.
+CGQMIN Minimum Acceptable Quality of Service Profile. Change should be at carrier's
request. Normally not required to be changed.