User guide

LAN/WiFi Configuration
Rev 2.0 C Aug.10 47
Figure 5-7: ACEmanager : LAN/WiFi - USB
Note: There is a USBnet/
USBserial driver for the
Win7 64 bit USB.
Note: The change to the USB mode is immediate and generally does not require a reboot..
Note: USB Serial works with Linx CDC-ACM driver.
Installing the USB drivers
Virtual Ethernet is the default setting for the USB port. If you want to install the
virtual serial port, change the Device Mode to USB Serial
When you connect the AirLink device for the first time to a USB port on your
computer, Windows should detect a new device and prompt you to install the
driver.
Note: Windows will see each port type as a different USB device and will see every port on
your computer separately. If you change the port type on the AirLink device or connect to a
different USB port on your computer or hub, Windows will see it as a new device.
Command Description
USB Device Mode *USBDEVICE=n
This parameter alters the default startup data mode for the USB port.
Device USB IP The USB/net IP address of the AirLink Device. By default this is set to 192.168.14.31.
1 - USBNET
0 - USB Serial
2 - Disabled
Host USB IP The IP for the computer or device connect to the USB port.
USB Serial Echo Toggle AT command echo mode when the USB is configured for virtual serial.
0 = OFF; 1 = ON