Network Router User Manual

PinPoint-E EV-DO
127 20070914
\APPP
SetmodemoperationtoPPPmode.Cannotbeconfiguredin
AceManager.\ASLIP
SetmodemoperationtoSLIPmode.DTRmustbeasserted
(&D0orS211=1).CannotbeconfiguredinAceManager.
\Qn
Setorquerytheserialportflowcontrolsetting.
• n=0:Noflowcontrolisbeingused.
• n=1:RTS/CTShardwareflowcontrolisbeingused.
• n=4:Transparentsoftwareflowcontrol.Usesescaped
XONandXOFFforflowcontrol.XONandXOFF
charactersindatastreamareescapedwiththe@character
(0x40).@indataissentas@@.
*CTSE=n
ClearToSendEnable:ThisfeatureassertsCTSwhenthereisa
networkconnection.
• n=0:Disabled(Default).
• n=1:EnableassertionofCTSwhenthereisnetwork
coverage.
RS232voltagelevels:
Positive = Network coverage.
Negative = No coverage.
Tip: Flow control (AT\Q) will override this indication, so if you want to
use CTS to indicate network coverage, flow control has to be off
(AT\Q0).
*NUMTOIP=n
Convert12digitnumbertoIP.
• n=0:Useasname.
• n=1:UseasIPaddress.
*PPPNOCARRIER=n
Providesa“NoCarrier”messagetoadeviceconnectedtothe
serialportusingPPPorCHAPwhenthecellularconnection
becomesunavailable.
• n=0:Disabled(Default).
• n=1:Enabled.