Network Router User Manual

PinPoint-E EV-DO
129 20070914
S221=n
ConnectDelay:Numberofsecondstodelaythe“CONNECTʹ
responseuponestablishingaTCPconnection.ORNumberof
tenthsofsecondstodelaybeforeoutputtingENQontheserial
portaftertheCONNECTwhentheENQfeatureisenabled
• n=0‐255
TCPS=n
TCPconnectiontime‐out(TCPS)units.Specifiesatimeinterval
uponwhichifthereisnoinoroutboundtrafficthroughaTCP
connection,theconnectionwillbeterminated.
• n=0:minutes
• n=1:seconds
TCPT=n
IntervaltoterminateaTCPconnectionwhennoinor
outboundtraffic.
ThisvalueaffectsonlytheTCPconnectionin
TCPPADmode.
• n=interval
Caution: TCPT should never be 0 when using the TCP mode. A
broken TCP session can result in the modem being left with a TCP
half-open connection that can only be terminated with a reset.
*ENQ=n
OutputsanENQ[0x05]aftertheTCPCONNECTdelayedby
theDelayConnectResponsetime(S221).
• n=0:Disabled(Default).
• n=1:EnableENQonCONNECT.
UDP
ThisgroupincludescommandsspecifictoUDPserialcommu‐
nications.