Network Router User Manual

Configuration Commands
Rev 3.0B Feb.08 138
Note: It may take up to 30 seconds for the hardware module to
respond after CONNECT is output.
*CSX1=n
PassThruEcho:Echodatatothe host.
• n=0:Datawillbepassedtothehost.
• n=1:PASSTHRUmodewillechoallhostreceiveddata
andwillnotpassthedatatothemodemwhilethemodem
isnotassertingDCD.
Note: If the modem is asserting DCD, data will be passed from the
host to the modem as it normally is when *CSX1=0.
*PTINIT=string
AnyATCommandstringtobepassedtotheOEMmodule
beforeenteringPASSTHRUmode,e.g.AT&S1V1,etc.
• string=ATcommand(s)
*PTREFRESH=n
NumberofminutesofinactivityinPASSTHRUmodeto
resendthe*PTINITstringtothehardwaremodule.
• n=0:Disabled
• n=1‐255minutes
*RESETPERIOD=n
InPASSTHRUmode,modemwillberesetafterthisperiodif
nodatahasbeensentorreceived.Valueisinhours.
• n=0:Disabled
• n=1‐255hours
SMTP
SMTP(SimpleMailTransferProtocol)isthedefactostandard
foremailtransmissionacrosstheInternet.ThePinPoint‐Ecan
sendmessagesusingSMTPifithasbeenconfiguredtousea
mailserver.
Note: You cannot send an Email with your PinPoint-E unless the
Email server you have configured allows your PinPoint-E as a relay
host. Talk to your network administrator to ensure you can send email
through the email server using your PinPoint-E.