Network Router User Manual

Configuration Commands
Rev 3.0B Feb.08 154
*PPTSV=n
TimerforStationaryVehicles.Timeint ervalinminutesthatthe
PinPoint‐Ewillsendinreportswhenitisstationary.
• n=0:Disabled
• n=1‐255minutes
Forexample,if*PPTIME=10,thePinPoint‐Ewillsendin
reportsatleastevery10secondswhileitismoving;however,
onceitstopsmoving,itwillslowthereportsdowntothis
*PPTSVvalue.
Note: In order for the PPTSV (Stationary Vehicle timer) to take effect,
the PPTIME value must be set to a value greater than 0 and less than
the PPTSV value. The PPTSV timer checks for vehicle movement at
the PPTIME interval, so if PPTIME is disabled, then PPTSV will also
be disabled.
*UDPRGPS=n
SetorqueryGPSstampingofUDPReliablepackets.Whenset,
datareceivedonthehostserialportwillbeencapsulatedwith
theGPSdateandtime.
• n=0:Disabled(default)
• n=1:Enabled
1x/EV-DO
Thisgroupincludescommandsspecificto1xandEV‐DO.If
youarenotconnectingtoamodemwhichusesEV‐DOor1x,
youwillnotseethisgroupinthemenu.
Figure 1-19: AceManager : 1x/EV-DO